The guide below walks gun owners through the basics of cleaning gun parts, but it is always best to follow any special instructions provided by the gun's manufacturer. Some kits also include a small brush, but a toothbrush will work just as well. Continue cleaning the barrel this way, replacing the cleaning patch each time it comes through the barrel. Dip the brush or toothbrush in the chemical cleaning solvent and clean the inside of the cylinder and gun frame.


Step 6
The final step is to lubricate the gun parts with the oil that came in the cleaning kit. Although these areas may be dirty, with proper and consistent cleaning, they will not have an excessive build up of dirt and debris. They are called Universal Cleaning kits and can usually be found at any gun or hunting supply store. There are different cleaning kits for different types of guns. With the proper care and cleaning, a gun can last a lifetime.


Step 3
Take out the gun cleaning kit designed for the type of gun being cleaned along with a supply of clean rags. After scrubbing, wipe the areas with a clean, dry rag to remove the dirt and chemical cleaner. For the novice, this may seem like an intimidating task, but by following the proper steps, the gun can be cleaned safely and effectively.


Step 4
Now it is time to begin the cleaning process. Replace the dirty, wet cleaning patch with a clean one and soak it with solvent when the rod pokes through the Screw Barrel For Plastic other end of the barrel. If you own more than one type of firearm, there are also cleaning kits that are made to work with a variety of gun types.


Step 2
Move to a well-ventilated work area with a large, flat surface to work on. Slowly push the rod into the barrel, cleaning the inside of the gun as it is pushed through. Take the time to store things neatly, so that the next time the gun is ready to be cleaned they can be easily found.


Once the gun is cleaned, put away the gun chemicals and work cloth. Attach a fresh cleaning patch to the end of the cleaning rod, soak it in oil and slide it into the gun's barrel and back out again. Before doing anything else, make sure that the gun is completely unloaded.
. Then, using a clean rag, apply a small amount of oil to the moving parts of the gun, testing them along the way to make sure that they are in good working order.


Step 5
Attach a cleaning patch to the end of the cleaning rod using a clip provided. As any gun owner knows, proper care means regular cleaning of the basic gun parts. The basic pieces of the cleaning kit include the following: a gun chemical cleaning solvent, oil for lubrication, a cleaning rod with clips and cleaning patches. Check the chamber and the barrel to make sure that it is free and clear of bullets.


Step 1
Unload the gun. It may take four or five times before the barrel is completely clean and a dry patch slides through with no residue left on it. Never skip this most important first step. The table or workbench should be covered by a soft cloth where the gun can be taken apart without worry of scratching or damage. The gun chemicals that will be used for cleaning have a strong odor, so proper ventilation is a must. Soak the cleaning patch with gun chemical cleaning solvent until it is saturated, but not dripping. Gun care is about being meticulous, patient and sticking to a routine

arrow
arrow
    文章標籤
    imm screw barrel
    全站熱搜

    screw barrel 發表在 痞客邦 留言(0) 人氣()